OH-XTM Super Chug fuselage ready for repairs

Suomeksi

After the Super Chug fuselage had been moved to the Puusepäntie workhop, the preparations to restore the damaged fuselage began. The first task was to detach the engine from the fuselage, because handling the damaged fuselage with the heavy engine in place would be nearly impossible.

Photo: Matti Kainulainen

So we started to detach the Super Chug’s VW 1600 engine from the fuselage together with the engine mounting. In doing so we’ll avoid detaching the wires, tubes and engine equipment within the engine mounting frame.

Photo: Jouni Ripatti

The engine mounting was attached to the fuselage with five bolts. We tried to open the nuts of the bolts that penetrated the firewall. The bolts, however, turned simultaneously when the nuts were turned. Somehow, we had to gain access to the bolt heads behind the firewall. If the nose of the aircraft were intact, gaining access to the bolts would be almost impossible, because the bolts were situated behind the fuel tank between the cockpit and the firewall. Now, however, the nose of the aircraft was torn because of the crash, so we could reach the bolts and unscrew the nuts.

Photo: Ari Aho

Photo: Antti Hietala

At the same time all the wires and cables, connecting the engine through the firewall, were detached. Part of them could be easily detached, but others fought us all the way. When the engine oil had been drained, we were ready to detach the engine.

Photos: Antti Hietala

Photo: Ari Aho

The engine was tied with cargo straps to an engine hoist, and the engine was pulled gingerly out of the nose of the Super Chug, hanging from the straps with the engine mounting. The detached engine was lowered on straps to a solid worktop to wait for further action.

The fuselage without the engine was still resting attached to a support frame made of pieces of four by two. Now the fuselage could be detached from the frame. The straps and other devices were opened, and the fuselage was carefully lifted from the supporting frame on to the table. We were a little apprehensive to lift the fuselage, nearly broken in half, but it held on well.

Because the fuselage of the OH-XTM has been damaged in the lower part between the cockpit and the firewall, it would be the most convenient, if the fuselage were to be on its back. So it was decided to place the fuselage on its back on two trestles, to facilitate the restoration work. One trestle would be by the cockpit opening and the other would support the rear fuselage at the stem of the vertical stabilizer.

We pondered what the suitable working height would be to restore the fuselage. It was decided to be 120 cm from the floor level. We adjusted the legs of the trestle by the cockpit so that the Super Chug’s fuselage top line, or in this case the damaged bottom line, would be at the height of 120 cm. The rear fuselage trestle had to be built.

It was built from the dismantled four by two pieces of wood of the Super Chug’s supporting frame. It resembled a normal wing trestle, only it was narrower. The level of the trestle was adjusted with a piece of fire hose used as strap, so that the whole of the fuselage was level and 120 cm from the floor.

After finishing the rear fuselage support trestle, the fuselage of the Super Chug was lifted upside down on the trestles. Thus the fuselage of the OH-XTM is ready for the restoration work.

Photos: Lassi Karivalo, unless otherwise mentioned

Translation to English: Matti Liuskallio