Preliminary steps for covering the Ressu (Snoopy) fuselage frame

Suomeksi

The fuselage of the Snoopy experimental aircraft (OH-XEA) was covered with fabric. When Aviation Museum Society Finland received the Snoopy two years ago, the fuselage was totally stripped of covering fabric. Therefore, the fuselage will be covered at the Tuesday Club as it originally was. Luckily we have some good photographs of the Snoopy at our disposal to guide us with the covering. So to work.

The whole fuselage frame of steel tube has been cleaned of rust during the autumn, given a layer of lacquer and finally painted with red Isotrol- paint. These jobs have been necessary for starting the work on the fuselage frame. These include the installing of the long wooden battens along the sides and upper surfaces of the fuselage frame and the partial covering of the fuselage frame steel tubes with fabric strip.

Metal brackets with 10 mm slots have been welded to the structure of both sides and the upper surface. Thin wooden battens have been fastened to these brackets along the whole of the rear fuselage. The purpose of the battens is to keep the covering canvas separated from the fuselage frame trusswork. Otherwise the metal would start to “eat” into the canvas, especially when rusting.

In order to prevent direct contact between the canvas and the longitudinal steel tubes at the upper and lower corners of the fuselage frame, cloth strip had been tied around the tubes. There were still remains of these strips left in the tail and vertical stabilizer of the Snoopy.

Next we started making the long protecting wooden battens. We found suitable material to make the battens at the restoration workshop’s woodware storage at the Finnish Aviation Museum. The battens were cut to measure and shaped to fit the brackets. At fitting the battens the brackets were squeezed tight to them. The batten was locked into place with small nails. Finally the battens that were fastened to the brackets, were protected with nitrocellulose lacquer.

Along with making the battens, we started covering the steel tubes of the fuselage frame with 20 mm wide cotton strip or tape. We bought that from Eurokangas. When the shop assistant queried what we needed it for, we said that it was used for covering a museum aircraft. The assistant was surprised but interested, so we briefed her in more detail about the purpose of the fabric strip. We must have been the first customer of this sort.

The ribbon was wound around the fuselage tubes to form a solid surface of fabric around the tubes. We wound the fabric strip to overlap the edge by about 5 mm. The stripping thus became solid, without any metal surface being visible. On the lower surface of the fuselage, without the wooden batten, we wound the strip on the lower part trusswork as well.

All the strip-covered surfaces were finally treated with nitrocellulose lacquer, which simultaneously glues the strip onto the tubes and later functions as an adhesive surface for the canvas covering. The covering canvas is tightened with that very same nitrocellulose lacquer.

Photos by Lassi Karivalo.

Translation by Matti Liuskallio.