Refurbishing the Snoopy pilot's seat

Suomeksi

The pilot’s seat of the Snoopy experimental aircraft, built by the brothers Hietanen from Turku, at the end of the 1960s, was moulded along the times. In the first version, the seat frame had a curved back support and a back rest of plywood, covered with fabric. Later the back rest became rectangular with an inset for the pilot’s parachute. The material of the back rest was changed at the same time from plywood to aluminium. With the inset in the back rest, the distance between the pilot and the control column could be increased, because the Snoopy’s seat isn’t adjustable. The parachute backpack worked as a padding for the pilot’s back.

Photo by Esko Keskinen.

The seat of the Snoopy, a donation to the Finnish Aviation Museum a few years back, consists of the back plate, side plates the shaped bottom plate and the case at the rear of the back rest. These parts have been riveted with pop-rivets to the steel tubes of the seat frame. A plywood plate, with a canvas-covered padding, attached with screws to the cockpit frame, forms the seat.

After tens of years in storage the Snoopy’s seat steel tube frame was rusty, like the fuselage frame, the aluminium parts of the seat were dirty and oxidized grey. The plywood seat plate with its padding had totally vanished.

To restore the seat, we started by detaching the aluminium parts fastened to the seat frame. They were detached by drilling away the pop-rivets that had fastened the aluminium parts to the frame.

After that we disassembled the seat frame of tubular structure, to be refurbished. We had our work cut out for us in doing that. We had to use a jack and a plastic mallet, before we were able to detach the frame parts from each other, because they were joined together with rust.

After separating the frame tubes, they were cleaned from rust to be painted in their original appearance. We did the cleaning by hand, using sandpaper of various grits and abrasive pads. We also did the same to clean the Snoopy’s fuselage frame tubes.

Because we’ll use Isotrol-lacquer to prime the seat frame, the tubes need not be sanded into clean metal. It suffices that the surface rust has been removed and that the surface of tubes feels smooth to touch. An Isotrol paint of the original shade will be painted on the Isotrol primer.

The dirty aluminium parts of the seat were cleaned with Fairy Power Spray agent. The Power Spray is a very efficient detergent for dirt and grease. You spray the agent on the surface of the part to be cleaned and leave it work for a few minutes.

After that the parts will be dried with a cloth or rinsed with water. In doing so we had the aluminium seat parts looking quite different, compared to when we detached them from the seat frame. The aluminium parts will still be buffed out before fastening them back to the restored and refitted seat frame.

Photos by Lassi Karivalo except if otherwise mentioned.

Translation by Matti Liuskallio.