Painting the Snoopy's rudder decals and taping them

Suomeksi

Unlike the other control surfaces, Snoopy’s rudder is covered with fabric. The other surfaces are covered with plywood. The paint on the rudder fabric was badly crackled and also tatty. That’s why we had to cover the rudder again. The new covering and the tightening with lacquer have been dealt with in the blog of May 6.

After the tightening with lacquer (shrinking dope) the fabric surface of the rudder was painted with the blue greyish Isotrol -oil paint the same shade as the original. The painting was done with a hand brush, because the Isotrol paint leaves a very smooth surface when painted with a hand brush.

Before painting the paint was filtered through a funnel to eliminate any lumps. The surfaces were painted twice over, after which the surface of the covering fabric was even and semi glossy. It was time to paint the speed lines and symbols the rudder once had.

On each side of the rudder there are red speed lines cutting diagonally across the surface. In addition, on the left-hand side of the upper part of the rudder there was number 2, and on the right-hand side a profile of a bird with spread wings. Did Esko and Ari Hietanen have a raven in mind?

Both the bird profile and the number 2 were copied on transparent paper from the old fabric that was detached from the rudder. From the paper they were transferred on to black contact plastic and cut off with scissors. Originally the symbols had been of black contact plastic, i.e. they weren’t painted on the rudder fabric.

First the red speed lines were made on the recently painted rudder. They were made exactly according to the originals, or copied from the covering fabric detached from the rudder. The shape of the speed line was bordered on the surface of the rudder with masking tape. The bordered area was painted with red Isotrol- paint. It’s of the same shade as the original. When the speed line on the left-hand side had dried, a similar line was painted on the right-hand side of the rudder.

Now the previously copied symbols, the bird figure and the number 2 could be fastened into place, number 2 on the left hand-side of the rudder and the bird figure on the right-hand side. The rudder restoration was ready.

Photos by Lassi Karivalo.

Translation to English by Matti Liuskallio.